28
Starting Procedure
Cold Electric Start Procedure
NOTE - You MUST ensure the
mower has the correct oil and fuel level
before operation.
!
STEP 1
Charge the battery with the 12V charger
supplied for 5 hours before first use and then
after every 10 uses on average. Plug battery
charger into battery socket.
STEP 2
Make sure the blade is free of long grass and
the cutting height is set to maximum.
Pump the primer bulb 5 times.
STEP 3
STEP 4
Pull the Operator Presence Control (OPC)
lever towards the main handle.
STEP 5
Turn the key. DO NOT keep the
key turned for longer than 5 seconds.
Once the lawn mower starts, release the key.
If the lawn mower fails to start after 5
seconds, release the key, wait 30 seconds
then try again.
To Next Page
Loading...
