ANGLE TRANSMISSION
7.31
The reduction gears are lubricated by multipurpose lithium based grease.
7.32
Add new grease after every 25 hours of use or more often depending on the job
condition.
STORAGE
7.33
Perform all the general maintenance procedures specified in this manual.
7.34
Clean the outside of the machine.
7.35
Remove all of the fuel from the fuel tank.
7.36
After the fuel has been removed, start the engine and allow it to run at idle until the
engine stops to remove all the fuel from the carburetor.
7.37
Allow the engine to cool down.
7.38
Remove the spark plug and pour 1 teaspoon of clean fresh 2 stroke engine oil into
the combustion chamber.
7.39
Slowly pull the starter rope several times to allow the oil to coat internal components.
7.40
Replace the spark plug.
7.41
Store the machine in a cool, dry place away from any source of ignition.
To Next Page
Loading...