PAC 212 - Residential Configuration

PAC 212 Access Controller Install Guide
7.3 Residential
7.3.1 Add / edit a flat
1. In the Admin menu or the Editor menu, choose Flats ①.
2. Type the number of the flat you want to add or edit (000–255), then press ↵ .
The Flat page is displayed.
7.3.2 Add a Key — Residential
1. In the Flat page, choose Add ①.
2. Use ④ and ⑥ to select a colour — red, orange, yellow, green, blue, grey, white, black —
then press ↵ .
Colours which are already in use for this flat are not available.
3. Present the key.
The Key page is displayed — see Configure a Key.
7.3.3 Edit a Key by Colour — Residential
This command is only available if you have added keys to the flat.
1. In the Flat page, choose Edit ②.
2. Use ④ and ⑥ to select the colour of the key to edit, then press ↵ .
The Key page is displayed — see Configure a Key.
7.3.4 Delete a Key by Colour — Residential
This command is only available if you have added keys to the flat.
1. In the Flat page, choose Del ③.
2. Use ④ and ⑥ to select the colour of the key to delete, then press ↵ .
The key is deleted and the Flat page is displayed again.
7.3.5 Delete All Keys — Residential
This command is only available if you have added keys to the flat.
1. In the Flat page, choose Del All ④, then press ↵ .
All keys are deleted and the Flat page is displayed again.
7.3.6 Edit a Key Quickly — Residential
To edit a key quickly:
1. In the Admin menu or the Editor menu, choose Flats ①.
2. Present an existing key.
The Key page is displayed — see Configure a Key.
- 10 -