PAC 212 - Specifications and Standards; Operating Environment; Battery Requirements; Approvals and Declarations

PAC 212 Access Controller Install Guide
5 Specifications and Standards
Temperature
Operating — interior equipment 0°C – 35°C
Humidity
Operating for 24 hours 10-85% RH @ 30±2°C [85±4°F]
Battery
Risk of explosion if battery is replaced by an incorrect type.
Use only 12Vsealed lead acid battery.
Dispose of used batteries in accordance with local and national regulations.
Approvals, Directives and Regulations
Hereby, Comelit-PAC Limited declares that the radio equipment type residential, commercial or
light industry door entry product is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address:
https://pacgdx.com/compliance-declarations
Declaration of Conformity available on request.
RoHS 2011/65/EU
WEEE 2012/19/EU
Do not discard this product along with other household waste.
It must be collected and treated separately.
6 First Setup
You will be prompted to setup the PAC 212 the first time it is switched on.
To set up the PAC 212:
1. Press and hold ⓪ for 5 seconds.
2. Press ↵ .to start setting up the PAC 212.
3. Enter the Admin PIN for this PAC 212, then press ↵ .
4. HF variant only – press ① to select OPS or ② to select OPS Lite, then press ↵ .
5. Present the required administrator token.
6. Select the system type – press ① for residential or ② for commercial, then press ↵ .
The PAC 212 is restarted and the settings are applied.
- 8 -