1. About this document
1.1 Function of this document
The document is only applicable for this EVSE (PacCharge AC20), including the variants and options
listed in section 11.1. The EVSE from here on in the document is referred to as the EVSE.
The document gives the information that is necessary to do these tasks:
• Installation
• Commissioning
1.2 Target group
The document is intended for qualified installation engineers.
For a description of the required qualifications, refer to section 3.2.
1.3 Revision history
Version Date Description
001 March 2020 Initial version
002 April 2021 Complete document overhaul
003 June 2022 PACCAR Version Update
1.4 Language
The original instructions of this document are in English (EN-US). All other language versions are
translations of the original instructions.
1.5 Illustrations
It is not always possible to show the configuration of your EVSE. The illustrations in this document show
a typical setup. They are for instruction and description only.
1.6 Units of measurement
SI units of measurement (metric system) are used. If necessary, the document shows other units between
parentheses () or in separate columns in tables.
1.7 Typographical conventions
The lists and steps in procedures have numbers (123) or letters (abc) if the sequence is important.
1.8 How to use this document
1. Make sure that you know the structure and contents of this document.
2. Read the safety chapter and make sure that you know all the instructions.
3. Do the steps in the procedures fully and in the correct sequence.
4. Keep the document in a safe location that you can easily access. This document is a part of the
EVSE.
7
To Next Page