Need help?Do you have a question about the Pace TD-100 and is the answer not in the manual?
General| Brand | Pace |
|---|---|
| Model | TD-100 |
| Category | Power Tool |
| Language | English |
Repair procedures must be performed by qualified personnel. Line voltage parts may be exposed when equipment is disassembled.
Adhere to safety guidelines in accordance with OSHA and other applicable safety standards to prevent personnel injury.
Heater cartridge tips are hot when powered on and for a period after power off. Do not touch tips to avoid severe burns.
Store handpieces in their holder to protect users from accidental burns and allow for cooling before storing.
Use PACE systems in a well-ventilated area. Fume extraction systems are recommended to protect personnel from solder flux fumes.
Exercise caution with chemicals like solder paste. Refer to MSDS and follow manufacturer's safety precautions.
Connect the handpiece connector plug into the power receptacle by aligning the guide, inserting, and locking clockwise.
Align key lock feature with handpiece notch and push cartridge fully in. MT-100 and TD-100 cartridges are not interchangeable.
Use hot grip removal pad to grasp and pull tip cartridge. Be careful as the tip may be hot and cause injury.
Details on Tip Cases holding 10 tips and Tip Stands for additional tip storage.
Part numbers for TD-100 handpieces (Heatwise/Tempwise, Intelliheat) and replacement cord assemblies.
Part numbers for the TD-100 Tool Stand and replacement O-rings for the TD-100.
Part numbers for MT-100 handpieces (Heatwise/Tempwise, Intelliheat) and MT-100 Tool Stands.
Part number for the Hot Grip Removal Pad.
List of standard conical, chisel, and bent tip cartridges with PACE P/N and descriptions.
List of specialized tips including heat staking, miniwave, and flat blade styles with PACE P/N.
Details on MicroFine and Micro-Wave tip cartridges with dimensions and PACE P/N.
Surface mount removal tips for TD-100, categorized by component type with dimensions and part numbers.
Surface mount removal tips for MT-100 MiniTweez, categorized by chip size with dimensions and part numbers.
Procedure to replace the O-ring on the TD-100 handpiece to protect the contact area.
Common symptoms like handpiece not heating, probable causes, and solutions such as changing tip cartridges.
Information on contacting PACE for service and repair, and the limited warranty statement.
To Next Page