15
2. Turn both the left and right treadbelt adjustment screws 1/2 turn
clockwise.
3. Walk on the treadmill to see if the adjustment you made decreased
the slippage.
4. If a significant decrease in slippage was observed, go to step 2.
If you tighten the treadbelt 1 1/2 turns per side and slippage is still
present, do not continue to adjust the treadbelt tension. Contact
your authorized PaceMaster dealer.
Figure 9
Troubleshooting
Problem Cause Solution
No power Unit is not plugged in Plug unit in.
Magnetic key is not in place Insert the magnetic key.
Household circuit breaker Reset the circuit breaker.
is off
Treadmill circuit breaker Reset treadmill circuit breaker
has been tripped (located next to power cord
on front of treadmill see figure 8, page 14).
If at any point prior to, during, or after your workout the treadmill does not function properly and displays an error message, make a note of the error
message and the conditions under which it occurred (i.e. speed, elevation, etc..). First you should run the treadmill again to see if the error message
occurs again under the same conditions. If it occurs again call the dealer where you purchased the treadmill and explain the problem so he can
arrange to service your treadmill.
Interference
1. Reorient or relocate the antenna for the device that is receiving the interference.
2. Increase the distance between the device and the treadmill.
3. Confirm that the device is not plugged into an outlet on the same circuit as the treadmill.
Specifications
Motor - 2.5 HP continuous duty DC @ 120 VAC/60 Hz., 18.8 Amps DC
Speed Range - .7 to 11.0 M.P.H. (.1 M.P.H. increments)
Elevation Range - 0 to 15% grade (.5% increments)
Operating Temperature Range - 50° to 100° F
Maximum Permitted Weight - 300 lbs.
© Aerobics, Inc. 1995
PaceMaster is a registered trademark of Aerobics Inc.
Workout Log
This page should be photocopied and used to keep a daily record of your workouts. By recording your
workouts on a copy of this page you will be able to keep track of your progress and this is also good for
To Next Page
Loading...
