-12-
Getting On and Off the PaceSaver
The following is a recommended method for getting on your PaceSaver.
1. The scooter should be stopped on a fl at, level surface with the key in the
OFF position.
2. Rotate the unlocked seat assembly to one side & re-lock.
3. Position yourself squarely in front of the seat and lower yourself into the
seat using the armrests if necessary.
4. Unlock the seat and rotate toward the front of the scooter. Lock the seat in
position by pushing down on the seat lock lever fi rmly. The seat will not move
when locked correctly. Lower the tiller to a comfortable angle. Never use the
tiller as a support while getting on and off the scooter.
5. When seated comfortably, you can drive the PaceSaver.
The method for getting off is the reverse procedure.
1. Turn the key switch OFF when stopped.
2. Raise the tiller out of your way.
3. Unlock the seat lock and rotate the seat to one side, then re-lock it.
4. Stand up carefully.
WARNING
Keep the key in the OFF position at all times when stopped or when getting on or off the scooter.
Sudden accidental movement of the scooter will be avoided with the key in the OFF position.
Tipping can occur if you get on the PaceSaver in a manner other than recommended.
Tipping can be avoided by keeping your weight away from the outer edges until seated.
If you step into the scooter, step near the center of the fl oorpan, not near the edge. Tipping
can also occur if you turn the steering tiller sharply while traveling at or near full throttle.
To Next Page
Loading...
