INFORMATION TO THE USER
***********************
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions :
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
NOTE : This equipment has been tested and found to comply with the
limits for a Class B digital device. Pursant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception. Which can be determined by turning the equipment off and
on the user is encouraged to try to correct the interference by one or
more of the following measures :
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for
help.
This booklet is available from the US government Printing Office
*washington, DC 20402, Stock No. 004-000-00345-4.
The shielded USB cable and IEEE-1394 cable with ferrite core
mounted are to be used in order to ensure compliance with FCC Part 15,
and it is the responsibility of the user.
CAUTION: Any changes of modifications not expressly
approved by the grantee of this device could void the users
authority to operate the equipment.
To Previous Page
Loading...