Pacific Power Source AFX Series

Need help?

Do you have a question about the Pacific Power Source AFX Series and is the answer not in the manual?

Summary

Safety & Warranty Information

Safety Information

Provides crucial safety guidance for installation and operation of PPS Equipment.

Safety Notices

Technical Specifications

Single Chassis Models

Lists technical specifications, including voltage and current ratings, for single chassis AFX models.

Multiple Chassis Models

Details specifications for multi-chassis AFX system configurations, including parallel operation.

AC Output Mode

Specifies parameters and performance for AC output operation, including voltage, current, and waveforms.

DC Output Mode

Details specifications and performance for DC output operation, including voltage and current limits.

Protection Modes

Lists the various protection modes available for the AFX Series® power source.

Metering

Transients

AC Input

Unpacking and Installation

Lifting and Carrying Instructions

Verify Correct AC Input Line Voltage

Instructions to verify AC input voltage configuration matches the local utility power.

AC Input Connections

Details requirements for AC input connections, including disconnect devices and wire sizing.

Grounding Requirements

Explains chassis ground connection requirements for electrical safety.

Load Connection Procedures and Setup

General guidance on connecting loads, including wiring, phase modes, and voltage sense.

AFX Cabinet Systems Turn ON and OFF Procedures

Front Panel Operation

PROGRAM Screen Features

Details programming parameters, soft keys, waveforms, and protection settings in the PROGRAM screen.

MEASUREMENT Screen Details

TRANSIENT Screen Operations

Covers transient programming, edit modes, execution controls, and entry modes.

CONFIGURATION Screen Options

Rear Panel, Connectors and Protection

OUTPUT Terminals

Details about the output terminal block for load connections, including ratings and isolation.

External Voltage Sense Connections

Remote Control Programming

Overview

Explains how interfaces enable remote configuration and data retrieval for the power source.

Calibration Command Details

Measurement Command Reference

Lists SCPI commands for querying measurement data like voltage, frequency, current, and power.

Output Control Commands

Details SCPI commands for controlling the output state, including fast startup modes.

Program Commands Reference

Covers SCPI commands for managing stored programs, including control, execution, and memory operations.

Source Command Reference

Details SCPI commands for configuring source parameters like voltage, frequency, and current.

Status Register Details

System Command Reference

USB Driver Installation

Installation

LAN Interface Configuration

Overview

Information on the AFX's LAN interface and automatic IP address acquisition.

Web Browser Interface

Access Control Mechanisms

Source Control Interface

Measurement Interface Screens

Configuration Interface Settings

Calibration

Closed Case User Calibration

Equipment Required

Calibration Procedure Steps

Details the step-by-step process for calibrating voltage and current offsets and gains.