22
Controller Guide
If an error is detected, the controller will display an error code. Refer to the following table for
descriptions and solutions:
Error Codes
P1 P2 P3
Firebox Theromocouple Sensor Failure
ER1
Touch “info”
icon to display
solution.
NOTE:
To dismiss an error
code, reboot the
controller by turning
seconds.
ERROR
CODE
ERROR DESCRIPTION SOLUTION
ER1
Failure
Check wiring connection from RTD to the controller. If wire
terminals are secure, RTD replacement may be required.
Ignition Failure
•
•
• Check ambient outdoor temperature. If RTD is too cold, the
pellets may ignite but not get the RTD warm enough within the
programmed time.
ER3
High Temperature Limit
Protection
• Allow grill to cool. Inspect cause of excessive temperature
•
Low Temperature Limit
•
•
Probe Communication Failure
Check meat probe connection at each port where attached.
probe.
ER9
Network Communication
Failure
of a strong network signal. Allow time for proper connection
TM
To Next Page
Loading...
