Pahlen Aqua-Mex User Manual (English)

Other manuals for Pahlen Aqua-Mex

Questions and Answers:

J
Jeffrey Jackson MDAug 2, 2025
How to troubleshoot a Pahlen Aqua-Mex FE Lighting Equipment when the heat exchanger pump doesn't start?
- M
  marie91Aug 2, 2025
  If the heat exchanger pump of your Pahlen Aqua-Mex FE lighting equipment doesn't start, first check the fuses in the electrical control box and verify the voltage matches the rating plate. Ensure the Aqua-Mex FE is receiving power, indicated by a dot on the display, and is switched on using the on/off button. Also, check the secondary circuit's flow, as the flow switch cuts out below 90 litres/min. Try setting a higher temperature. Examine the motor for blockages from deposits and manually check the rotor's movement with a screwdriver after fully unscrewing the air screw.
T
Timothy CalhounAug 7, 2025
Why is my Pahlen Aqua-Mex FE Lighting Equipment heating even when the primary circulation pump is off?
- A
  andrew67Aug 8, 2025
  The primary heat source may provide self-circulation over Aqua-Mex due to the pressure differential difference between the inlet and return.
J
Joshua GarnerAug 14, 2025
What to do if the heat exchanger pump does not start on my Pahlen Industrial Equipment Aqua-Mex FE?
- P
  pennythomasAug 14, 2025
  If the heat exchanger pump of your Pahlen Industrial Equipment Aqua-Mex FE does not start, here are a few things to check: * First, inspect the fuses in the electrical control box. * Verify the voltage matches the rating plate data. * Ensure the Aqua-Mex FE is receiving power, indicated by a dot on the display. * Confirm the Aqua-Mex FE is switched on using the on/off button. * Try setting a higher temperature. * Make sure the motor isn't blocked by deposits. * Finally, fully undo the air screw and use a screwdriver to check the rotor's free movement.
B
brandtmonicaAug 20, 2025
Why is the temperature of the primary circuit’s water not high enough in my Pahlen Industrial Equipment?
- G
  Gary SimonAug 20, 2025
  If the temperature of the primary circuit's water is not high enough in your Pahlen Industrial Equipment, you should: * Check the heating source. * Ensure that the primary piping is properly insulated. * Verify that the heat exchanger is installed correctly, so the primary and secondary circuits operate in opposite directions.