11
5.2. OPERATING
INSTRUCTIONS
ON/OFF
To turn the unit ON,
press the ON/OFF button of the
unit and hold for 3 seconds. You
will hear a long beep and the
white LED lights will switch on.
The unit will turn OFF
automatically when the session
is complete (60 minutes in
programme 1 and 20 minutes in
programme 2). A long beep will
indicate the end of the session
and the device switching off.
If you wish to manually turn the
unit OFF, press and hold the
ON/OFF button for 3 seconds.
You will hear a long beep (1
second) and the white LEDs light
will switch off.
Note: Always check unit
is OFF before applying
or removing the QALM
device from the forehead.
Note: Always clean the
forehead before using
the device.
PROGRAMME CONTROL
The ON/OFF button is also the
programme select button.
QALM has two pre-set
programmes.
Every time the unit is switched
on, the programme 1 is
automatically selected. If you
wish to change to programme 2
press and release the ON/OFF
button. Programme 2 selection
will be indicated by two short
beeps.
To change back to programme
1, press and release the ON/OFF
button. A single beep will
indicate programme 1 has been
selected.
Every time a new programme is
selected, the strength level is
reverted to zero. This is a safety
feature to alleviate any sudden
feeling of a surge, as each
programme gives a different
sensation.
STRENGTH CONTROLS
The buttons marked ˄, ˅ are the
strength controls.
To increase the intensity in steps
of 0.5 mA press and release the
˄ button. To increase
To Next Page
Loading...
