Palazzani
Palazzani Industrie spa
OM 386 pag 5 Cap 3
BATTERY CHARGES
The battery charges is fitted into the general electrical box.
1. Connect the machine net cable to a plug 230V
– 50 Hz.
2. After this operation the battery charger (in the
electric box) light on automatically and the three
leds light on contemporarely for few seconds
(self-diagnosis)
3. Then the batteries recharging proces starts and
the led shows the recharging status
4. Battery charges doesn’t need any maintenance
or intervention
A warning light with flashing leds is mounted to
signal any eventual anomaly during the charge.
Battery charger, is placed on the platform and it is
connected at its electric panel
During working with electric motor, the external
electric plug feeds the motor and this device
maintaining the batteries efficient.
Batteries are also re-charged by the alternator of
the diesel engine.
RISK OF BURN
When the electrolyte is freezed it can make the battery explodes if you try to
charge it or to start the thermic motor with a secour battery.
To avoid to the electrolyte to freezes, maintain the battery always charged,
disconnect always the negative pole (-) at firs and connect it always at last;
never bridge the battery poles.
The electrolyte causes big burns, avoid the contact with skin, eyes, clothes.
External: wash with water.
Internal: drink a big quantity of water or milk. Ask to a doctor.
Eyes: wash with water for 15 minutes and ask immediately to a doctor.
To Next Page
Loading...