NOTE: Always use a digital voltmeter when checking voltage to determine if you
have sufficient power to operate the liftgate.
The liftgate should have a 150A Resettable Circuit Breaker and a 15A ATC Fuse in
the electrical circuit set up. These were installed at the liftgate was mounted.
Location of
150A Circuit
Breaker
Check fuse by removing cap.
Replace with
15A ATC fuse
(BLUE) if metal
bridge is broken.
Cab Cut Off Switch
Located in cab of truck. Must be on for liftgate to operate.
PLR Electrical Components
11
To Next Page
Loading...
