Check for broken power wire in release valve cable:
• Unplug connector at valve.
• Set multimeter to read DC voltage.
• Put positive lead of multimeter in plug.
• Put negative lead of multimeter in other hole of
plug.
• Activate down function on gate.
• Preferred reading should be 10V or higher.
Check for broken wire in release valve cable:
• Set multimeter to OHM function.
• Place a test lead of the multimeter at each end of
the wire.
• If there is resistance in the wire, then the
continuity test is positive and will show a value
on the multimeter.
• If the amount of resistance shows zero (0), then
the wire is broken.
Power Cable to Release Valve Coil Test
25
To Next Page
Loading...
