Need help?Do you have a question about the Palmer Macht 402 and is the answer not in the manual?
Introduction to the Palmer MACHT 402 guitar power amplifier.
General safety instructions for equipment operation.
Specific safety rules for connecting to the power mains.
Caution regarding potential hearing damage from high sound levels.
Warning about electric shock risks at speaker outputs.
Guidelines for safe installation and connection practices.
Operation of power, volume, and low-frequency equalizer controls.
Controls for treble frequencies and low-frequency rumble filtering.
Explains the function of Clip and Protect LEDs for amplifier status.
Details mode selection switch and associated indicator LEDs.
Guide to setting mains voltage and activating the Stand-by mode.
Information on connecting speakers via Speakon and Jack outputs.
Details the specific output for bridge mode operation.
Operation of Ground Lift and Limiter switches.
Adjusting input sensitivity for optimal signal-to-noise ratio.
Details XLR and 6.3mm Jack balanced input connectors.
Wiring diagrams for XLR, TRS Jack, and Speakon connectors.
Key technical data including output power, THD, and frequency response.
Details display elements, cooling, power supply, dimensions, and weight.
Manufacturer's warranty conditions and liability limitations.
Guidelines for correct and environmentally friendly product disposal.
General| Channels | 2 |
|---|---|
| Type | Solid-state |
| Power Output | 400W per channel at 4Ω |
| Outputs | binding posts |
| Frequency Response | 20 Hz - 20 kHz |
| Input Impedance | 20kΩ |
To Next Page
