17
WARNING:
concerning the use of the device by a person who is responsible for their safety.
Supervise children to ensure they do not play with the device.
ASSEMBLY
IMPORTANT:
Read the “Important Safety Instructions” section before using the device.
NOTE: Always remove the plug from the outlet before installing or removing accessories.
1. Insert the hose connector (3) in the connection (11) until it is properly adjusted. To remove the flexible
2. Adjust the length of the telescopic metal tube (1) putting pressure on the tube block (6) and pulling the
telescopic tube to the desired length. The tube will lock automatically when you release the lock. See fig. 2.
3. Secure the end of the telescopic metal tube (1) to the handle (4) of the flexible hose (2). See fig. 3.
Affixing accessories
4. Set the floor brush attachment (7) at the end of the telescopic metal tube (1). See fig. 4.
can be affixed to the telescopic metal tube (1) or directly to the hose handle (4).
OPERATION
1. Pull the cord to the desired length. Do not pull the excess cord.
CAUTION:
Pull the cord to the maximum length indicated by the yellow flag. Never pull the cord up to the red flag since
the cord winding mechanism may be damaged.
2. Insert the plug into the electrical outlet.
fig. 5.
Suction power control
1. Suction power can be adjusted by the vacuum flow controller (5). Close the suction controller for full
suction or open it for diminished suction. See fig. 6.
2. Turn the power controller (18) to adjust the unit’s power. See fig. 5.
Storage
automatically. See fig. 5.
Normal position
2. Hook in the floor brush attachment (7) to the available groove on the back of the vacuum. See fig. 7.
Upright Position
3. Hook in the floor brush attachment (7) to the available groove on the lower part of the vacuum See fig. 8.
To Next Page
Loading...
