6.Care and Maintenance
5.6. Memory
If it is necessary to interrupt a blood pressure measurement for any reason
(e.g the patient feels unwell), the Start/Stop button can be pressed at any
time. The device then immediately lowers the cuff pressure automatically.
If short press, it goes into standby mode and displays three zeros and
symbol. If long press, the device will shut down.
5.7. Discontinuing a Measurement
Wash hands after each time measurement.
If one device is used by different patients, wash hands before and after
each use.
a) Do not expose the device to either extreme temperatures, humidity,
dust or direct sunlight.
b) Clean the device with a soft, dry cloth. Do not use gas, thinners or
similar solvents. Spots on the cuff can be removed carefully with a damp
cloth and soapsuds. The cuff with bladder must not be washed in a
dishwasher, clothes washer, or submerged in water.
c) Do not drop the monitor or treat it roughly in any way. Avoid strong
vibrations.
d) Never open the monitor! This invalidates the manufacturer’s warranty.
e) Batteries and electronic instruments must be disposed of in accordance
with the locally applicable regulations, not with domestic waste.
6.1. Accuracy test
Sensitive measuring devices must be checked for accuracy from time to
time. We recommend a periodical inspection of your unit by an authorized
dealer every 1 year. Please turn to local distributor or the manufacturer.
Put up
Fragile
Afraid of the rain
Fear of the sun
Class ll equipment
Handle gently
Temperature range
No Sterilize requirement
Not category AP / APG equipment
Mode of operation: continuous
At the end of a measurement, this monitor automatically stores each result .
It will store 120 sets measurements .
The degree of avoid ingress of water or particulate matter into ME equipment
To Next Page
Loading...