Need help?Do you have a question about the Panamax MAX 5100 and is the answer not in the manual?
General| Input Voltage | 120V |
|---|---|
| Input Frequency | 50/60 Hz |
| Output Voltage | 120V |
| Surge Protection | Yes |
| Number of Outlets | 10 |
| Clamping Voltage | 330V |
| Maximum Input Current | 15A |
| EMI/RFI Filtering | Yes |
| Maximum Surge Current | 50kA |
| Cord Length | 6 ft |
Explains the filtration system for audio/video components, focusing on common mode interference.
Five lights on the front panel indicating power disturbances or activated features.
Four always-on, filtered outlets for components requiring constant power.
Four switched, filtered outlets with delay options for components not needing constant power.
Two delayed outlets for high-current components like amplifiers, offering unimpeded power.
Protects against excessive current draw by tripping to open the circuit.
1/8 inch jack for 12VDC remote signal to control startup/shutdown sequence.
Protection for satellite and cable TV signal lines with optimized clamping levels.
Surge protection for telephone lines used for Pay-Per-View services.
Provides delays for High-Current outlets and Outlet Bank 2 to prevent transient issues.
Details the 'Balanced L' filtration circuits for eliminating AC contamination.
Policy on using Panamax extension cords for warranty validity.
Troubleshooting steps for signal loss through coax/phone cables.
Explanation of Protect or Disconnect™ circuitry sacrificing itself during strikes.
Defines surges and spikes by duration, voltage, and common causes.
Explains unsafe voltage levels, duration, and causes for over/undervoltages.
Defines EMI (Electromagnetic Interference) and RFI (Radio Frequency Interference).
To Next Page
