Panasonic AG-AC130 - AC Adaptor and Hand Strap

24
Using the AC adaptor
Installation
1
Connect the DC cord to the AC adaptor.
2
Plug the AC cord into the power outlet.
3
Insert the DC cord’s battery connector until
it clicks into place.
DC cord’s battery connector
Removal
1
Turn the POWER/MODE switch <OFF> (Page 27),
and confirm that the mode lamp is off.
2
Remove the DC cord’s battery connector
while pressing the battery release button.
3
Disconnect the AC cord from the power
outlet.

•
ThebatterycannotberechargedwhenaDC
cordisconnectedtotheACadaptor.

•
DisconnecttheACcordfromthepoweroutlet
whenthisdeviceisnotinuse.
CAUTION:
• This apparatus can be operated at a volt-
age in the range of 110 – 240 V AC.
Voltages other than 120 V are not intended
for U.S.A. and Canada.
Operation at a voltage other than 120 V AC
may require the use of a different AC plug.
Please contact either a local or foreign
Panasonic authorized service center for as-
sistance in selecting an alternate AC plug.
Adjusting the hand strap
Adjustthehandstraptosuityourhand.
1
Open the cover and adjust the length of the
strap.
2
Close the cover.

•
Makesurethatthecoverisrmlyclosed.