Panasonic AG-AC160A - Charging Batteries

Pg. 3
Step-by-Step Shooting Guide
Power Up, Set to P2 Camera Mode:
1) Make sure the Power Switch is OFF
If it was left on, push in the little white
button and rotate it to OFF
2) Slide a battery into the slot on the rear
surface of the camera. Push it in near the
top of the opening, and slide it down until it
locks into place.
The arrow on the battery label should be
point down when in position.
OR
3) SlidetheACpoweradaptorintothesame
slot. The other end of the cable connects to
the jack on the front of the adaptor.
4) Turn on the POWER.
Remember, push in the little white button to
rotate the switch to the ON position.
Charging Batteries
5) IfnotusingtheACpoweradaptortopower
the camera, you can use it to recharge the
batteries.
The battery slides onto the slot on the top
oftheACPowerSupplybox.
 TheCHARGElightwillcomeonwhile
charging,andgooutwhennished.Each
battery will require up to 4 hours to fully
recharge if completely drained.
NOTE:Youcan’tchargeabatteryatthesame
time you are using the adaptor as a power
supply! You should completely unplug both
ends of the cable that runs from the camera to
theACpowersupplyboxwhencharging.
NOTE! There are 2 larger batteries,
and 1 smaller battery with each cam-
era. The large batteries should last for
at least 4 hours, the small for about 3.
O
F
F
O
N
M
O
D
E
1
2
O
F
F
O
N
M
O
D
E
O
F
F
O
N
M
O
D
E
3
4
5