5.12. MDA/DC SCHEMATIC DIAGRAM
5.13. FDM (FRONT, DV CONN & MIC) SCHEMATIC DIAGRAMS
5.14. FDM (FRONT, DV CONN & MIC) CIRCUIT BOARDS
5.15. MECHA & MECHA CONN SCHEMATIC DIAGRAMS
5.16. MECHA & MECHA CONN CIRCUIT BOARDS
5.17. IC BLOCK DIAGRAMS
6. Mechanical Replacement Parts List & Exploded
Views
NOTE:
1. Be sure to make your orders of replacement parts according to this list.
2. Unless otherwise specified, all resistors are in OHMS, K=1,000 OHMS, all capacitors are in
( F), P= F.
3. The P.C. Board unit marked with " " shown below the main assembled parts.
4. The parts marked with on the exploded view show the electric parts.
5. IMPORTANT SAFETY NOTICE
Components identified with the mark have the special characteristics for safety. When
any of these components, use only the same type.
6. The marking (RTL) indicates the retention time is limited for this item. / After the
assembly in production, it will no longer be available.
7. “(M)” in Remark column indicates needed in the periodical maintenance.
7. Electrical Replacement Parts List
10
To Next Page
Loading...
