No.
Item Ref. Illustration Procedure
2-23
27 Cassette LED/ LED holder/ MECHA board assembly <Disassembly>
Cassette LED:
1)Remove solder from LD1 on the mechanism board
and remove the cassette LED.
LED holder:
1)While pushing the three claws locking the LED
holder, remove it.
MECHA board assembly:
1)Remove the seven screws (S2) and a screw (S3),
then remove the MECHA board assembly.
<Assembly>
1)Reverse the disassembly procedure.
2)Tighten the eight screws of the mechanism board
assembly in the order shown in the illustration.
(
S2
)
(
S2
)
(
S2
)
(
S2
)
(
S3
)
Cassette LED and LED holder
MECHA board
Fig. 2.6.27 (1)
5 4
1 78
6
3 2
LD1
LED
holderlock
section
Fig. 2.6.27 (2) — Mechanism unit bottom side —
Note:
Makce sure the three claws locking of the LCD
holder does not loosen.
To Next Page
Loading...
