No.
Item Ref. Illustration Procedure
2-22
25
e
FPC1 assembly
<Disassembly>
FPC2 assembly:
1)Remove solder from CN126 on the mechanism
board.
2)Remove the FPC2 assembly as if peeling adhesive
tape off.
FPC3 assembly:
1)Remove solder from CN127 on the mechanism
board.
2)Remove the FPC3 assembly as if peeling adhesive
tape off.
<Assembly>
1)Reverse the disassembly procedure.
<Disassembly>
1)Remove the M.I.C connector and idler arm assem-
bly as described in section 2.6.7.
2)Remove solder from the M.I.C connector (6 posi-
tions).
3)Remove the FPC1 assembly by performing the
same operation as peeling adhesive tape off for
the idler cover section.
<Assembly>
1)Reverse the disassembly procedure.
26 FPC2 assembly/ FPC3 assembly
Fig. 2.6.25
Fig. 2.6.26 (1)
FPC1
Idler cover
M.I.C connector
Soldering on the reverse.
Match the hole to the boss
of an idler cover.
FPC3
FPC2
Note:
Do not reuse the removed FPC1 assembly.
Note:
Do not reuse the removed FPC1 and FPC2 as-
semblies.
Fig. 2.6.26 (2)
CN126
CN127
To Next Page
Loading...
