25
4-7 Contents of Menu Switches
[ ]: Factory setting • The lower section in the items and set values columns shows what’s on the VCR’s display.
4 ON-SCREEN/MENU SWITCHES
FunctionScreens Items Set values
CNT TAPE END [OFF]
500
1000
.
.
.
9500
OFF
500
.
.
.
9500
Outputs a tape end signal from the rear panel’s [TAPE END OUT] terminal
when the tape reaches the set tape reel counter value during recording.
During series recording, a series recording signal is output to a connected
VCR for continuous recording.
OFF: The counter end output function is disabled.
500 : A tape end signal is output when the set tape reel counter value is
reached during recording. A buzzer sounds when the menu switch
<TAPE END> on the <BUZZER> is set to “ON”.
For more information on the relationship between the tape reel
counter value and the tape remaining time, refer to page 55.
SR ET 2
.
.
.
9500
SR ET 3
ALARM/ REC MODE [OFF]
SENSOR ALARM
MODE SENSOR
AL/SENSOR
OFF
ALAR
SENS
ALKS
Selects the alarm recording or sensor recording function.
• Alarm recording: When an alarm signal is input to the rear panel’s
[ALARM IN] terminal during recording, the mode switches to the 2H/6H/
L12H/L18H/L24H/24H/48H/NORMAL or 6H (EP) recording mode for
realtime recording of the alarm event.
• Sensor recording: When an alarm signal is input to the rear panel’s
[ALARM IN] terminal in the Stop mode (Stop mode, Timer Recording
Standby or Operating Off mode), recording starts in the 2H/6H/L12H/
L18H/L24H/24H/48H/NORMAL mode.
OFF: Alarm or sensor recording is not executed.
ALARM: Alarm recording is executed.
SENSOR: Sensor recording is executed.
AL/SENSOR: Both alarm and sensor recording are executed.
AL SE 1
SRI/EXT SRI/EXT REC [OFF]
MODE SERIES
EXT
OFF
SERi
EiT
Selects series recording or automatic recording with an external VCR activation
signal.
OFF: The series recording and automatic recording with an external
signal functions are disabled.
SERIES:The series recording function is enabled.
EXT: The automatic recording function with an external signal is enabled.
* When the menu switch <REPEAT REC> is set to “ON”, externally
activated recording is not executed.
EXT REC END [NORMAL]
POWER OFF
NORn
POFF
Selects the mode engaged when externally activated automatic
recording ends.
NORMAL: The Stop mode is engaged.
POWER OFF: The Stop mode is engaged and the operating power
mode is turned off.
REPEAT REC [OFF]
ON
OFF
ON
VTR MODE
Enables or disables the repeat recording function.
OFF: The repeat recording function is disabled.
ON: When the tape ends, it is automatically rewound and recording
starts again from the beginning. When set to “ON”, the [REPEAT]
indication on the VCR’s display lights.
*
If the menu switch <TAPE END MODE> on the <ALARM/SENSOR
MODE> screen is set to “STOP”, the Stop mode is engaged when
the tape ends even when there is an alarm or sensor recording. The
repeat recording is not executed.
* When this menu switch is set to “ON”, externally activated recording
is not executed.
VTR 7
(VCR's display)
SR ET 1
To Next Page
Loading...
