Panasonic Aquarea WH-SDC09H3E5-1 - Connecting the Water Outflow to the Safety Valve

170 Aquarea air-to-water heat pumps - Planning and installation manual - 01/2018
Installation
171
Aquarea air-to-water heat pumps - Planning and installation manual - 01/2018
Installation
Hydro-module H-Generation
Carry out the following steps to connect the outow hose to the water outlet socket of the safety
valve of the hydro-module:
1. Slide the outow hose onto the condensation outlet socket on the hydro-module.
2. Ensure that the outow hose is seated rmly. Use a hose clip to attach the hose, if neces-
sary (to be provided on site).
3. Lay the outow hose in a constant downward alignment into a suitable collection xture
for the condensation (to be provided on site).
Detail view from below
1
1 Water outlet socket of the
safety valve
6.7.2.2 Connecting the water outow to the safety valve
Combination Hydro-module H-Generation
For the combination hydro-module of the H-Generation, a safety valve (initial pressure 8 bar) is
integrated into the hot water tank. Safety valve and hot water tank have a common water outlet.
!
IMPORTANT
Also use the following instructions at the time of installation of the condensation outlet on the
combination hydro-module of the H-Generation:
● The outow pipeline may be maximum 2 m long and have not more than 2 bends.
Carry out the following steps to connect the outow line to the water outlet socket of the safety
valve of the combination hydro-module:
1. Use a connection of the size R ½ inches for installing the outow line.
2. Lay the outow line in a consistently downward alignment. The end of the outow pipeline
must be visible and must not be near electrical components.
3. It is advisable to insert an outow siphon in the outow line, which is also visible and is
not in the vicinity of electrical components.
1
1 Water outlet socket of the
safety valve