Panasonic AVCCAM AG-AC160P - Changing Backlight Brightness; Flipping Images Up, Down, Left and Right

8
Changing backlight brightness
The brightness of the LCD monitor backlight can
be adjusted between ve different settings.
1
Select [LCD BL] in the [LCD] item on the
setup menu [SW MODE] screen.
[LCD BL] is assigned to the <LCD> button.
2
Press the <LCD> button.
Each time the button is pressed, the backlight
brightness changes in the following order:
0 (normal)

-1 (somewhat dark)

-2

-3
(dark)

+1 (bright)

0 (normal).
• The setting will be saved even if the power is
switched off.
• It can also be switched with the [LCD
BACKLIGHT] item on the setup menu
[DISPLAY SETUP] screen. (Page 95)
Flipping images up, down, left and right
By ipping the images displayed on the LCD
monitor up, down, left and right, the angle of view
and imagery of images can be checked.
Even when the displayed image is ipped, the
recorded image is not ipped.
1
Select [LCD REV] in the [LCD] item on the
setup menu [SW MODE] screen.
[LCD REV] is assigned to the <LCD> button.
2
Press the <LCD> button.
Pressing the button switches between normal
display and flipped display.
• If the power of the camera is switched off, it will
appear in normal display when next switched
on.
• Screen displays other than images are also
ipped. When screen display is not needed,
press the <DISP/MODE CHK> button to turn
off some displays.
• During ipped display, images in REC CHECK
and playback images in <PB> mode are also
ipped.
• Images on the viewnder are not ipped.