Panasonic AVCCAM AG-HMC41E - Power Sources; Using the Battery; Using the AC Adapter

23
Preparation
Power sources
Using the battery
Installation
Insert the battery until it clicks into place.
ヱャ
ヲヶリヤレチヴヵモン
ヵ
ヱラヰヵ
ヰ
ヤモヮユン
モ
Removal
1
Set the POWER switch to OFF, and check
that the mode lamp is off.
2
Remove the battery while pressing the
battery release button.
Support the battery with your hand to ensure
that it will not fall.
ヱャ
ヱヰヸユ
ン
ヲヶリヤレチヴヵモン
ヵ
ヱラヰヵ
ヰ
ヤモヮユン
モ
Mode lampBattery release button
•
Using the AC adapter
Installation
1
Connect the DC cable to the AC adapter.
2
Plug the AC power supply cable into the
power outlet.
3
Insert the DC cable’s battery connector until
it clicks into place.
2$
1
(
(

1
0

/
1
&
'
219'4
37+%-56#46
2*161
%#/'4#
#8176
%1/210'06
176
%#/4'/16'
<11/55
(1%75+4+5
DC cable’s battery
connector
Removal
1
Set the POWER switch to OFF, and check
that the mode lamp is off.
2
Remove the DC cable’s battery connector
while pressing the battery release button.
3
Disconnect the AC power supply cable from
the power outlet.
Battery cannot be recharged when the DC
cable is connected to the AC adapter.
CAUTION:
Disconnect the AC power supply cable from the
power outlet when the unit is not going to be used.
•
•