Remember your password. If you forget the password, you cannot use the Win-
dows. Creating a password reset disk beforehand is recommended.
The wallpaper for the fi rst logon user has already been set on “
4
Setup Windows.” .
When using this computer under the Sun, the screen becomes easily viewable
by changing the wallpaper to the white wallpaper.
A
Right-click on the desktop, and click [Personalize] - [Desktop Background].
B
Select [Solid Colors] at [Picture Location].
C
Select the white wallpaper and click [Save changes].
When you set date/time/time zone and click [Next], the screen may not go to the
next step for a few minutes. Do not touch the keyboard or touch pad, and wait
until the screen changes.
If “An unexpected error has occurred ...” (or a similar message) is displayed,
click [OK]. This is not a malfunction.
Wait until the hard disk drive indicator has turned off.
6 Perform the touchscreen calibration.
<Only for model with touchscreen>
NOTE
At fi rst, log on to Windows as an administrator, and perform this calibration.
Return the rotated display to [Primary Landscape] before the touchscreen calibration.
A
Click (Start) - [Control Panel] - [Hardware and Sound] - [Tablet PC Setting].
B
Using the stylus, touch each of the “+” target marks one by one.
NOTE
Perform the following calibration for each user.
A
Click (Start) - [Control Panel] - [Hardware and Sound] - [Tablet PC Setting].
B
Click [Calibrate].
C
Using the stylus, touch each of the “+” target marks one by one, and then click [Yes].
Perform the calibration for the orientation to be used.
A
Click [start] - [All Programs] - [Fujitsu Touch Panel (USB)] - [Touch Screen
Calibration Utility].
B
Using the stylus, touch each of the 12 “+” target marks one by one until it
blinks, and then press
Enter
.
C
Press
Enter
.
<Only for model with Dual Touch>
NOTE
Perform these calibration for each user.
If you cannot touch the desired position, perform Digitizer Calibration again and
restart the computer.
A
Run [Tablet PC Settings].
Click (Start) - [Control Panel] - [Hardware and Sound] - [Tablet PC Settings].
B
Click [Calibrate].
C
Select [Pen input].
D
Using the digitizer pen, touch each of the “+” target marks one by one, and
then click [Yes].
Perform the calibration for the orientation to be used.
A
Run [Tablet and Pen Settings].
Double-click or click [start] - [Control Panel] - [Printers and Other Hard-
ware] - [Tablet and Pen Settings].
B
Click [Settings] - [Calibrate].
C
Using the digitizer pen, touch each of the 4 “+” target marks one by one, and
then click [OK].
Perform the calibration for both [Landscape] and [Portrait].
To Next Page
Loading...
