114
SD Memory Card Security Function
A [Private] folder will be created in the SD memory card, and a Windows log-on
user name and password will be registered.
Do not delete [Private] folder. Doing so will cancel [Use when logging on to
Windows].
z To use both when starting the computer and when logging on to Windows
Add the check mark to both [Use when starting computer] and [Use when logging
on to Windows], and input Supervisor Password, user name, and other information
according to the instructions on the screen (Î page 111)
If the Function fails to Operate Correctly
z The computer does not respond properly when you insert the SD memory card.
Remove the card and wait a few seconds, then reinsert it. Or, enter each password
z The SD memory card indicator is blinking.
Enter the password through the keyboard without removing the SD memory card.
A software application, etc. may be accessing the SD memory card
z The password input screen and the Windows log-on screen do not appear.
If [Leave set] was selected as the setting method:
• If an SD memory card is already inserted when starting the computer, each screen
does not appear when the computer is started
• If an SD memory card is already inserted when resuming from the standby or
hibernation mode, or while the screensaver is active, reinsert it
When logging on to Windows / When resuming from the standby or hibernation mode,
or the screensaver
z If [Set and eject] was selected as the setting method:
Insert the SD memory card, then eject it after you hear a beep indicating card recognition
(When the speaker function is disabled, e.g., by the key combination the
Fn
+
F4
key,
there will be no beep sound)
To Next Page
Loading...
