155
Setup Utility
Set Supervisor Password
• Set a Supervisor Password if you wish to prevent any unauthorized changes to the Setup Utility
settings, also if you require a password on boot, set [Password on boot] to [Enable] after you set
Supervisor Password
To the sub-menu
Setup Utility Prompt
• Select whether to display ([Enable]) or not to display ([Disable]) the message “Press F2 for
Setup/F12 for LAN” shown on the bottom of the [Panasonic] boot screen that is displayed after
starting this computer
Disable
Enable
Boot First Menu
• Select whether to display “Boot Menu” ([Enable]) or not ([Disable]) (Î page 156)
Disable
Enable
Hard Disk Lock
• Select whether enable ([Enable]) or disable ([Disable]) the hard disk lock
• This function will not work without the Supervisor Password being set
Disable
Enable
User Password Protection
• Select whether to permit changing the User Password ([Protected]) or not ([No Protection])
No Protection
Protected
Set User Password
• Set User Password when multiple users use this computer, etc.
For example, when the system administrator sets Supervisor Password and User Password and
lets other users know only the User Password, other users cannot change some of the settings
in Setup Utility
• This function will not work without the Supervisor Password being set
To the sub-menu
(An u
nderline indicates the factory default settings)
To Next Page
Loading...
