171
Dealing with Problems (Advanced)
The red indicator blinks z Quickly save your data and power off your computer. Remove the battery pack
and disconnect the AC adaptor, then connect them again. If the problem
persists, contact your technical support office. The battery pack or charging
circuit may be defective
The orange indicator blinks z Battery cannot be recharged temporarily because the internal temperature of
the battery pack is outside the acceptable temperature range for recharging.
Once the range requirement is satisfied, charging begins automatically. Your
computer can be used normally in this state
Keyboard
Only numbers can be input
z Check whether the indicator is on. If it is on, the computer is in ten-key
mode. To disable the ten-key mode, press the
NumLk
key (Î page 26)
Only capital letters are being input
z Check whether the indicator is on. If it is on, the computer is in Caps Lock
mode. To disable the Caps Lock mode, press the
Caps Lock
key (Î page
25)
How to input European characters (ß,
à, ç etc.), symbols or Euro currency
symbol is unclear
z Display the character map and point to the desired font name, such as
European fonts, and select it with the following procedure.
Click [start] - [All Programs] - [Accessories] - [System Tools] - [Character Map]
Networking: General
Unable to connect to a network z Confirm that either [Modem], [LAN] or [Wireless LAN] is set to [Enable] in the
Setup Utility (Î page 153)
z When using the computer as a network computer, some additional settings may
have to be made depending on the usage conditions. We recommend asking
your system administrator or the person in charge of the network
z If the standby or hibernation mode is entered, the computer may have to be
restarted
z If the link lamp on the HUB unit is not on and the network cannot be accessed,
set the speed to match the HUB unit (Î page 135)
Battery Indicator
To Next Page
Loading...
