Station Preset
Direct Memory
Up to 6 stations can be preset in AM, FM1, FM2, and FM3
respectively.
Preset stations can be simply called up by pressing one of the
preset buttons from
[1] to [6].
Auto Preset Memory (APM)
With this operation, stations with good receiving conditions can
be automatically stored in the preset memory.
1
Select a band.
2
Hold down [BAND] (APM) for more than 2
seconds.
The preset stations under best receiving conditions are
received for 5 seconds each after presetting the stations
(SCAN). To stop scanning, press one of the preset but-
tons from
[1] to [6].
Note: New stations overwrite existing saved stations.
Manual station preset
1
Tune into a station.
2
Hold down one of the preset buttons from
[1] to [6] for more than 2 seconds.
(blinks once)
Note: New stations overwrite existing saved stations.
Your favorite FM/AM radio station can be memorized in the
[D·M] button and you can call back the radio station just by
pressing the button whatever the current sound source is,
even if the power is off.
D•M station calling
1
Press [D•M] (Direct Memory).
Press again to cancel.
D•M station writing
1
Select a station you would like to preset.
2
Hold down [D•M] for more than 2 seconds.
lights while receiving an FM stereo signal.
Band Preset NumberFrequency
Display change
Press [DISP] (Display) to change the display.
Radio mode display (Default)
Radio Mode Display
Clock display
lights while receiving the D•M (Direct Memory)
station.
CQ_C1103UOIeng_M-90% 10/21/2005 3:39 PM 頁面 12
To Next Page
Loading...
