General
English
Power on
Press [SOURCE] (PWR: Power).
Notes:
¡ The opening screen appears.
¡ The demonstration message appears for first use. (a
Page 8)
Power off
Hold down [SOURCE] (PWR) until you
hear a beep (about 1 sec.), then release it.
Note: The ending screen appears at ACC on.
10 11
You can remove the face
plate to prevent it from
being stolen.
Removing
1
Press []
(Release).
(The face plate disen-
gages with a click
when it is removed.)
The front panel automatically closes after a lapse of
5 seconds while it is open.
The power is automatically turned off while the unit
is active.
2
Put the face
plate in the case.
Mounting
1
Slide the left side of the removable face
plate in place.
2
Press the right end of removable face
plate until “click” is heard.
Press it until you hear a click.
Cautions:
¡ This face plate is not waterproof. Do not expose it to
water or excessive moisture.
¡ Do not remove the face plate while driving your car.
¡ Do not place the face plate on the dashboard or
nearby areas where the temperature rises to high
levels.
¡ Do not touch the contacts on the face plate or on the
main unit, since this may result in poor electrical
contacts.
¡ If dirt or other foreign substances get on the con-
tacts, wipe them off with clean and dry cloth.
¡ To avoid damaging the front panel, do not push it
down or place objects on it while it is open.
Notes:
¡ The volume level can be set independently for each
source. (For radio, one volume setting for AM
(MW/LW), one volume setting for all FMs)
¡ The volume is not adjustable while an error display is
on the monitor. (a page 36)
q Up
w Down
Setting Range: 0 to 40
Default: 18
Volume off (down)
Press [MUTE].
( lights.)
Cancel
Press [MUTE] again.
Note:
Volume-down range can be specified. (
a
Page
17)
General
This chapter explains how to turn on or off the power, how to adjust the volume, etc.
Power On/off
(PWR: Power)
Face Plate Removing/Mounting
(Anti-Theft System)
Volume Adjustment
(VOLUME)
Temporary Volume Off
(Down)
MUTE (ATT: Attenuation)
Radio
FM1, FM2, FM3, AM (MW/LW) (a Page 18)
The source changes as follows every time [SOURCE]
is pressed.