Panasonic CQ-DFX983N

11
CQ-DFX983/903N
English
10
CQ-DFX983/903N
Up to 6 stations can be preset in AM, FM1, FM2, and FM3 respectively.
Preset stations can be simply called up by pressing (P·SET Preset}) or
(P·SET Preset{).
Note: Direct selection can be executed with remote control buttons ~ .
Auto Preset Memory (APM)
1
Select a band.
2
Hold down (APM Auto Preset Memory) for 2 sec. or more.
Up to 6 best receiving stations are preset.
The preset stations under best receiving conditions are received for 5 sec. each after presetting
the stations (SCAN). To stop scanning, press (P·SET Preset}) or (P·SET
Preset{).
Notes:
¡ New stations overwrite existing saved stations.
¡ Only RDS stations will be saved at default setting (AF ON). To select non RDS stations too, set AF
OFF.(a Page 13)
Manual station preset
1
Tune in to a station.
2
Hold down (P·SET Preset}) or (P·SET Preset{) for 2
sec. or more.
3
Select a preset number by pressing
(P·SET Preset}) or
(P·SET Preset{).
4
Preset the station by holding down
(P·SET Preset}) or (P·SET Preset{)for 2 sec. or more.
Frequency/preset number blinks once.
Notes:
¡ New stations overwrite existing saved stations.
¡ In step 2, a station can be registered by holding down the numeric button ~ 2 sec. or
more.
¡ To stop presetting stations, press (DISP Display).
6
1
6
1
Radio Basics
This chapter explains how to listen to the radio.
TA
P
W
R
CQ-DFX983N
M
U
T
E
S
O
U
R
C
E
T
U
N
E
/
T
R
A
C
K
OPEN
1
Press (SOURCE) to select the radio
mode.
2
Press (BAND) to select a band.
3
Select a station
Station search
Lower: Hold down (TUNE]) for 0.5 sec. or more
then release it.
Higher: Hold down (TUNE[) for 0.5 sec. or more
then release it.
Frequency adjustment
Lower: Press (TUNE]).
Higher: Press (TUNE[).
Preset station selection
Lower preset number:
Press (P·SET Preset{).
Higher preset number:
Press (P·SET Preset}).
Note: Direct selection can be executed with to
buttons on remote control.
6
1
Band
STEREO/MONO (Monaural) Indicator
Operation Flow
Notes:
¡
For tuning in on only stations whose receiving condi-
tions are good in the station search, set LOCAL to ON.
(
a Page 12)
¡ For reducing noise when a receiving FM stereo wave is
weak, set FM MONO to ON. (
a Page 12)
Radio mode display
Band
Frequency
LOCAL Indicator
Preset Number
Preset number
Often-tuned
Station Preset
(Preset)