E
N
G
L
I
S
H
2
17
CQ-DP383U
E
N
G
L
I
S
H
1
16
CQ-DP383U
General
Note:
≥ When the power is switched on for the
first time, a demonstration message ap-
pears on the display.
To cancel this display, press [DISP]
(display).
Power (POWER)
Turn your car’s ignition key to ACC or ON
position.
ON: Press [POWER].
OFF: Press and hold [POWER] again on the
main unit for more than 1 second.
Press and hold [POWER] again on the
remote control unit for more than
2 second.
1
Source (SRC)
Press [SRC] (source) to change the source.
2
Remote control signal sensor
Point the remote control unit at the main unit’s
sensor.
Remote Control Unit Preparation
1 Remove the battery holder.
Pull the battery holder by the position B while
pushing position A in the direction indicated by
the arrow.
2 Install the battery on the battery holder.
3 Insert the battery holder back into its original
position.
≥ Remove and dispose of an old battery immediately.
≥ Do not disassemble or short the battery. Do not
throw a battery into a fire.
≥ Keep batteries away from children to avoid the
risk of accidents.
≥ Be careful to observe proper local disposal rules
when you dispose of batteries.
Caution:
≥ Improper use of batteries may cause overheat-
ing, an explosion or ignition, resulting in injury
or a fire. Battery leakage may damage the unit.
Lithium battery
(included)
Back side
Position B
Position A
Battery holder
Battery Installation
Battery Notes
≥ Battery type: Panasonic lithium battery (CR2025)
(included)
≥ Battery life: Approximately 6 months with nor-
mal use (at room temperature)
[DISP] (display)
Accessories
≥ Warranty card, etc.
For details on the Sirius mode, refer to the
separate operating guide for Sirius.
≥ To display the message again, press and
hold [SRC] (source) on the main unit for
more than 4 seconds when the power is
off.