– 29 –
MAC9512086C2
CS-C181KE
Servicing Information
(A) Disassembly of the parts
● Inspection points for the Indoor Electronic Controller
1. The Electronic Controller, a signal Receiver and an
Indicator can be seen by removing the Front Grille
and Control Board Cover, as shown in the Fig. 1.
● Indoor Fan Motor removal procedure
1. Remove the connector CN-FM (GREEN) of Fan
Motor and connector CN-STM (GREEN) of stepping
motor from the electronic controller. Release the
earth wire (YELLOW-GREEN) from the control board
terminal and sensors from its holders. (Refer Fig. 2.)
2. Remove the Control Board.
As shown in Fig. 3, remove the 3 screws and release
the tab at the top of Control Board (Fig. 4). Pull the
Control Board forward slightly.
Caution: Removal of Discharge Grille before removing
the control board is necessary to avoid
damaging other parts.
Fig. 4
Fig. 1
Indicator
9
8
0
290
d
ir
e
c
t
i
o
n
A
ir
i
n
t
a
k
e
A
ir
o
u
t
l
e
t
d
i
r
e
c
t
i
o
n
L
e
f
t
p
i
p
i
n
g
h
o
le
L
o
w
e
r
p
ip
i
n
g
h
o
le
C
181KH01.DWG
J9790188 CS/CU-C181K
<
F
ro
n
t
V
ie
w
>
Signal Receiver
Electronic
Controller
Fig. 2
Sensors
Earth Wire
Connector
CN-FM
Connector
CN-STM
Screws
Fig. 3
Taps
Untitled-5 6/19/00, 5:24 PM29
To Next Page
Loading...
