30
Note: Knife switch (Disconnecting means) should have minimum 3.5 mm contact gap.
Secure the cable onto the control board with the holder (clamper).
11.3.5. Pipe Insulation
1. Please carry out insulation at pipe connection portion as mentioned in Indoor/Outdoor Unit Installation Diagram. Please wrap
the insulated piping end to prevent water from going inside the piping.
2. If drain hose or connecting piping is in the room (where dew may form), please increase the insulation by using POLY-E
FOAM with thickness 6 mm or above.
To Next Page
Loading...
