4
0!4 2 / ,
3%.3/2
• In heat mode, it takes a while for the unit to warm up. The
power indicator blinks during this operation.
HOW TO OPERATE
Remote
control
display
REMOTE CONTROL TRANSMITTER
AUTO MODE - FOR YOUR CONVENIENCE
HEAT MODE - TO ENJOY WARM AIR
• Make sure it is not
obstructed.
• Certain fl uorescent lights
may interfere with signal
transmission. Please
consult your nearest
dealer.
Maximum distances : 8m
RECEIVER
Close
Insert AAA or
R03 batteries
Pull out
Inserting the batteries
• The batteries can be used for approximately 1 year.
Replace the batteries when the remote control display or
transmission signal becomes weak.
Setting the current time
Select Turn on Adjust
temperature
Set time
Confi rm
Press
INDICATOR
• Unit selects the operation mode according to temperature
setting, outdoor and room temperature.
• Operation mode is reselected every 30 minutes. During
operation mode selection the power indicator blinks.
Notes:
• Press
RESET button to restore the remote control’s
default setting.
• For normal operation, the
and RESET buttons are not
in use.
• While using remote control, please be aware of the OFF
indication on the remote control display to prevent the unit
from starting / stopping improperly.
• PATROL operates automatically once the unit is switched on
with
button.
COOL MODE - TO ENJOY COOL AIR
• During soft dry operation, the indoor fan operates at low
fan speed to give a very gentle cooling operation.
● The range of temperature for selection is
16°C ~ 30°C.
●
Operating the unit within the recommended
temperature could induce energy saving.
HEAT MODE : 20°C ~ 24°C.
COOL MODE : 26°C ~ 28°C.
DRY MODE : 1°C ~ 2°C lower than room temperature.
DRY MODE - TO DEHUMIDIFY THE
ENVIRONMENT
To Next Page