PRODUCT OVERVIEW
Multi Air Conditioner Function
● It is possible to operate the indoor units individually or simultaneously.
● During operation, heating and cooling modes could not be activated at the same time for different indoor unit.
● The power indicator blinks to indicate the indoor unit is standing by for different operating mode.
LCD display
Off/On
Clock setting
Memory reset
Temperature setting
Powerful operation
Operation mode
Quiet operation
Timer setting
Fan speed selection
Airflow direction
adjustment
Transmitter
Remote Control
For use with DT & DD-series
indoor unit
Check
1. Press and
pull out
2. Insert batteries
(AAA or R03)
3. Press CLOCK button
4. Set
current
time
Remote Control
Outdoor Unit
Air inlet (rear)
Air outlet
Air inlet (side)
For use with DK-series indoor unit
LCD display
Temperature setting
Powerful operation
Memory reset
Clock setting
Quiet operation
Operation mode
Ion operation
Airflow direction
adjustment
Timer setting
Off/On
Fan speed selection
Transmitter
Check
• Make sure it is not obstructed.
• Maximum distances : 8m.
• Certain fluorescent lights may
interfere with signal transmission.
Consult your dealer.
Remote Control Preparation
Remote Control Signal
• Timer operation will be based on
current time set.
• The batteries can be used for
approximately 1 year.
• The batteries must be
recycled or disposed of
properly.
1. Pull out
2. Insert batteries
(AAA or R03)
3. Press CLOCK button
4. Set
current
time
5. Press again to confirm
OR
■ About
5. Press again to confirm
To Next Page
Loading...
Need help?
General
