8
REMOTE CONTROL
11
Press and hold for 5 seconds to dim or restore the
unit’s indicator brightness.
12
Press and hold for approximately 10 seconds to
show temperature setting in °C or °F.
13
Press to restore the remote control’s default setting.
14
Not used in normal operations.
The unit stops and the timer indicator blinks.
Use remote control to retrieve error code.
ON
OFF
SET
CANCEL
TIMER
123
SET CHECK CLOCK RESET
AC
RC
1
Press for 5
seconds.
3
Press for 5
seconds to
quit checking.
2
Press until you hear
beep sound, then
write down the error
code.
Note:
• For certain errors, you
may restart the unit for
limited operation with 4
beeps during operation
starts.
4
Turn the unit off and reveal the error code to authorized dealer.
ON
OFF
SET
CANCEL
TIMER
123
SET CHECK CLOCK RESET
AC
RC
11
13
14
TO SET THE TIMER
• 2 sets of ON and OFF timers are available to turn ON
or OFF the unit at different preset time.
• Complete below procedures to set each timer:
ON
OFF
1
Cancel
Cancel
2
SET
3
Select ON or OFF timer
Set the
time
Confi rm
• Example of application at living room:
Morning: ON
at 07:00 (Wake up)
OFF at 08:00 (Out for work)
Evening: ON at 17:00 (Back home)
OFF at 22:00 (Sleep)
• To cancel ON or OFF timer, press
ON
or
OFF
to
select respective or then press
CANCEL
.
• If timer is cancelled manually or due to power failure,
you can restore the timer again by pressing
ON
or
OFF
to select respective or then press
SET
.
• Upcoming timer will be displayed and will be activated
in sequence.
• When ON Timer is set, the unit may start earlier (up
to 35 minutes) before the actual set time in order to
achieve the desired temperature on time.
• Timer operation is based on the clock set in the
remote control and repeats daily once set. For clock
setting, please refer to Remote Control Preparation at
back cover.
12
F568133-YS0311-0_1EN.indd 8F568133-YS0311-0_1EN.indd 8 07-Jun-11 9:59:13 AM07-Jun-11 9:59:13 AM
To Next Page
Loading...
Need help?
General
