5
ENGLISHENGLISHENGLISHENGLISH
4)-%2
, , and operations are available in all
modes and could be cancelled by pressing the respective button
again.
and or and operations could not be
activated at the same time.
and operations could be activated even when the
air-conditioner is turned off. In this condition, once e-ion indicator
is ON, the unit will operate with AUTO fan speed and air swing.
However,
operation could not be activated if other indoor
unit is activating heating operation.
TO MONITOR AIR QUALITY
• This setting enables the patrol sensor
to automatically detect the air quality.
• When the air quality is unsatisfactory,
e-ion operation will start automatically.
• When ON Timer is set, the unit may start earlier (up
to 35 minutes) before the actual set time in order to
achieve the temperature you preferred.
• The timers repeat daily once set.
• If there is a power failure, you can restore the
previous setting (once power is resumed) by pressing
the
button.
• If the timer is cancelled, press
to restore the
previous setting.
The timer is based on the time set in the remote
control.
You can set your preferred time for ON and OFF
timers.
TO ENJOY QUIET ENVIRONMENT
• This setting provides a quiet environment by
reducing the airfl ow noise.
TO SELECT FAN SPEED
• There are 5 fan speeds, as well as
automatic*.
* For automatic fan speed, the speed
of the indoor fan is automatically
adjusted according to the operation.
TO ACHIEVE TEMPERATURE QUICKLY
• This setting enables the desired
temperature to be reached quickly.
Select ON
or OFF
timer.
Set the
desired
time.
Confi rm
the setting.
Hints
Temperature setting of 1°C higher in cool mode or
2°C lower in heat mode than the desired temperature
performs a 10% power saving.
To reduce power consumption during cool mode, close
the curtains to prevent the sunlight and heat from
coming in.
To disable the PATROL operation during unit start with
, press and hold for 5 seconds then
release.
To reset, press
again for 5 seconds then release.
To set either 12-hour (am/pm) or 24-hour time
indication, press and hold
for approximately 5
seconds.
To dim the indicator display on the air conditioner:
Press and hold
for 5 seconds.
To reset, press again for 5 seconds.
To switch the temperature setting to °C or °F, press and
hold
for approximately 10 seconds.
To cancel ON or OFF timer, press
or , then press .
• When you want the air conditioner to turn ON or OFF
automatically at a preset time.
TO SET THE TIMER
TIMER SETTING
To turn off the air conditioner, press .
TO ENJOY CLEAN AIR
• This setting provides clean air by producing
negative ions to attract dust which will then
be captured at the positively charged e-ion
fi lters.
TO ADJUST AIRFLOW DIRECTION
• Keeps the room ventilated.
• There are 5 options for vertical airfl ow
direction.
• If automatic vertical airfl ow direction
has been set, the louvers swing up/
down automatically.
• In heat mode, the air blows horizontally
for a while, then starts to blow
downwards.
• Do not adjust the vertical airfl ow
direction louvers by hand.
• Horizontal airfl ow direction louver is
manually adjustable.
To Next Page
Loading...
