8
CARE & CLEANING CARE & CLEANING
WASHING INSTRUCTIONS
• Do not use benzene, thinner or scouring powder.
• Use only soap ( pH7) or neutral household detergent.
• Do not use water hotter than 40°C.
HINTS
• Clean the lter regularly for best performance and to
reduce power consumption.
• Please consult your nearest dealer for seasonal
inspection.
FOR SEASONAL INSPECTION AFTER EXTENDED
FOR SEASONAL INSPECTION AFTER EXTENDED
NON-USE
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• After 15 minutes of operation, it is normal to have the
following temperature difference between air inlet and air
outlet vents:
Cooling: 8°C Heating: 14°C
NON SERVICEABLE CRITERIAS
NON SERVICEABLE CRITERIAS
TURN OFF POWER SUPPLY then CALL Authorized
Distributor under the following conditions:
• Abnormal noise during operation.
• Water/foreign particles have entered the remote control.
• Water leaks from Indoor unit.
• Circuit breaker switches off frequently.
• Power cord becomes unnaturally warm.
• Switches or buttons are not functioning properly.
FOR EXTENDED NON-USE
• Activate Heat mode for 2~3 hours to remove moisture left in
the internal parts thoroughly.
• Turn off the power supply.
• Remove the remote control batteries.
Clean with dry cotton bud.
• Active e-ion generator
cleaning is recommended
every 6 months.
Wipe the unit gently with a soft,
dry cloth.
ALUMINIUM FIN
• Clean the lters regularly.
• Wash/rinse the lters gently with water
to avoid damage to the lter surface.
• Dry the lters thoroughly under
the shade, away from re or direct
sunlight.
• Replace any damage lter.
ACTIVE e-ion POWER MODULE
ACTIVE e-ion POWER MODULE
FRONT PANEL
Raise and pull to remove. Wash
gently and dry.
Remove
CAUTION
• Switch off the power supply before cleaning.
• Do not touch the aluminium n, sharp parts may cause injury.
To Next Page
Loading...
