N
or
OFF
then
press
CANCEL
.
• When ON Timer is set, the unit may start earlier (up
to 35 minutes) before the actual set time in order to
achieve the desired temperature on time.
• Timer operation is based on the clock set in the
remote control and repeats daily once set. For clock
setting, please refer to Remote Control Preparation at
back cover.
• If timer is cancelled manually or due to power failure,
you can restore the previous setting (once power is
resumed) by pressing
SET
.
6
TO ADJUST AIRFLOW DIRECTION (5 OPTIONS)
AIR SWING
• Keeps the room ventilated.
• In COOL/DRY mode, if AUTO is set, the louver swing
left/right and up/down automatically.
• In HEAT mode, if AUTO is set, the horizontal louver fi x at
predetermined position. The vertical louver swing left/right
after the temperature rises.
7
TO ENJOY QUIET OPERATION
• This operation reduces airfl ow noise.
8
TO REACH TEMPERATURE
QUICKLY
• Single Split System: This operation stops automatically
after 20 minutes.
• Multi Split System: Press the button again or turn OFF the
unit to stop this operation.
9
Press and hold for 5 seconds to dim or restore the
unit’s indicator brightness.
10
Press and hold for approximately 10 seconds to
show temperature setting in °C or °F
11
Press and hold for approximately 5 seconds to show
12-hour (am/pm) or 24-hour time indication.
12
Press to restore the remote control’s default setting.
13
Not used in normal operations.
To Next Page
Loading...
Need help?
General
