ENGLISH
9
FOR SEASONAL INSPECTION AFTER EXTENDED
NON-USE
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• Use Auto OFF/ON button to select Cooling/Heating
operation. After 15 minutes of operation, it is normal to
have the following temperature difference between air
inlet and air outlet vents:
Cooling: ≥ 8°C Heating: ≥ 14°C
FOR EXTENDED NON-USE
• Activate Heat mode for 2~3 hours to remove moisture left
in the internal parts thoroughly to prevent mould growth.
• Turn off the power supply and unplug.
• Remove the remote control batteries.
SERVICEABLE CRITERIAS
TURN OFF POWER SUPPLY AND UNPLUG then please
consult authorized dealer under the following conditions:
• Abnormal noise during operation.
• Water/foreign particles have entered the remote control.
• Water leaks from Indoor unit.
• Circuit breaker switches off frequently.
• Power cord becomes unnaturally warm.
• Switches or buttons are not functioning properly.
INFORMATION
Information for Users on Collection and Disposal of Old Equipment and used Batteries
[Information on Disposal in other Countries
outside the European Union]
These symbols are only valid in the European
Union. If you wish to discard these items,
please contact your local authorities or dealer
and ask for the correct method of disposal.
Note for the battery symbol (bottom two
symbol examples):
This symbol might be used in combination with
a chemical symbol. In this case it complies with
the requirement set by the Directive for the
chemical involved.
Pb
Models Number
Single Split System
CS-E9NKKW / CU-E9NKK
CS-E12NKKW / CU-E12NKK
CS-E18NKK / CU-E18NKK
Multi Split System
CS-E12NKKW, CS-E12NKKW / CU-2E18NBK
The above listed models have been designed and manufactured to meet ENERGY STAR
®
criteria for
energy effi ciency when matched with appropriate coil components. However, proper refrigerant charge
and proper air fl ow are critical to achieve rated capacity and effi ciency. Installation of this product should
follow the manufacturer’s refrigerant charging and airfl ow instructions. Failure to confi rm proper charge and
airfl ow may reduce energy effi ciency and shorten equipment life.
To Next Page
Loading...
Need help?
General
