45
11.1.6.1 Wire Stripping and Connection Requirement
11.1.7 Installation of Decorative Panel
The decorative panel has its installation direction. Confirm the direction by displaying the piping side.
1 Remove the air inlet grille by moving the catchers to center.
2 Fitting the decorative panel
o Temporarily secure the fixing screws (3
pcs.) before fitting the decorative panel.
(For temporarily securing the front grille.)
o Place decorative panel on the screws (3
pcs.) before fitting, move decorative
panel as illustrated and tighten all the
screws (4 pcs.).
Check before hand the height from the ceiling to
the unit.
The front grille fitting direction is determined by
the unit direction.
Only use the screws with the length of 35mm
which is provided, to fix the decorative panel.
Do not use other screw which is longer it may
cause damage to the drain-pan and other
components.
To Next Page
Loading...
