Why does my Panasonic Air Conditioner POWER indicator blink before I switch it on?
The POWER indicator on your Panasonic Air Conditioner might blink before you switch it on as a preliminary step in preparation for operation when the ON timer has been set. When the ON Timer is set, the unit may start earlier (up to 35 minutes) before the actual set time in order to achieve the desired temperature on time.
What to do if my Panasonic Air Conditioner's HEAT/COOL mode isn't working efficiently?
If your Panasonic Air Conditioner isn't heating or cooling efficiently, make sure that you set the temperature correctly, close all doors and windows, clean or replace the filters, and clear any obstructions at the air inlet and outlet vents. Also, check if the circuit breaker has tripped or if any timers have been set.
Why does my Panasonic Air Conditioner's outdoor unit emit water or steam?
The water or steam emitted from the outdoor unit of your Panasonic Air Conditioner is due to condensation or evaporation occurring on the pipes.
Why is there discoloration of some plastic parts on my Panasonic CS-TE35TKEW Air Conditioner?
Discoloration of some plastic parts on your Panasonic Air Conditioner is subject to the material types used and is accelerated when exposed to heat, sunlight, UV light, or environmental factors.
What causes light sensor open or short circuit in Panasonic CS-TE35TKEW Air Conditioner?
If the light sensor in your Panasonic Air Conditioner has an open or short circuit, it may be due to a defective or disconnected light sensor.
What causes dust to accumulate on the wall near my Panasonic CS-TE35TKEW Air Conditioner?
Dust accumulation on the wall near your Panasonic Air Conditioner is due to air circulation or static electricity generated by the unit. Some types of wallpaper may collect dust easily, so it's recommended to clean the area around the air conditioner frequently.
Why is there a delay after restarting my Panasonic Air Conditioner?
Operation is delayed a few minutes after restarting as a protection mechanism for the unit’s compressor.
Why POWER indicator blinks in HEAT mode of Panasonic CS-TE35TKEW?
The POWER indicator blinks during HEAT mode with no warm air supply (and flap is closed) because the unit is in defrost mode (and AIR SWING is set to AUTO).
Why does my Panasonic CS-TE35TKEW Air Conditioner make a water flowing sound during operation?
The water flowing sound you hear during operation of your Panasonic Air Conditioner is due to the refrigerant flow inside the unit.
Why is the cooling/heating capacity reduced on my Panasonic CS-TE35TKEW Air Conditioner at the lowest fan speed?
If you've noticed a reduction in cooling/heating capacity during the lowest fan speed setting on your Panasonic Air Conditioner, it's because the low fan speed prioritizes low noise operation, which can reduce cooling/heating capacity. To increase capacity, increase the fan speed.
Instructions for installing batteries into the remote control.
Procedure for setting the unit's clock.
Important safety guidelines for unit operation and handling.
Specific safety measures for units using R32 refrigerant.
Precautions for refrigerant handling and proper installation procedures.
Routine checks to perform before contacting technical support.
Conditions requiring immediate consultation with an authorized dealer.
Procedure to access and interpret diagnostic error codes from the unit.
List of diagnostic displays and their corresponding abnormalities/protections.
General| Type | Air conditioner indoor unit |
|---|---|
| Multi-split | No |
| Product color | White |
| Inverter technology | Yes |
| Timer duration (maximum) | 24 h |
| Air conditioner functions | Cooling, Heating |
| Heating capacity in watts (max) | 5100 W |
| Heating capacity in watts (min) | 800 W |
| Cooling capacity in watts (nominal) | - W |
| Seasonal efficiency rating (cooling) (SEER) | - |
| Heating capacity in watts (nominal) (Average heating season) | 4000 W |
| Seasonal efficiency rating (heating) (SCOP) (Average heating season) | 4.1 |
| Airflow | 708 m³/h |
| AC input voltage | 230 V |
| Design load (cooling) | 3.5 kW |
| Energy efficiency class (cooling) | A++ |
| Annual energy consumption (cooling) | 201 kWh |
| Hourly energy consumption (cooling) | - kWh |
| Design load (heating) (Warmer heating season) | - kW |
| Design load (heating) (Average heating season) | 2.8 kW |
| Annual energy consumption (heating) (Average heating season) | 956 kWh |
| Indoor unit type | Wall-mountable |
| Indoor unit depth | 290 mm |
| Indoor unit width | 799 mm |
| Indoor unit height | 197 mm |
| Indoor unit weight | 8000 g |
| Indoor units quantity | 1 |
| Heating airflow (indoor unit) | 750 m³/h |
| Indoor unit noise level (high speed) | 58 dB |
| Outdoor unit noise level | - dB |
To Next Page
