7
Q
UIE
T
P
OWE
RF
UL
ION
TIM
E
R
P
O
W
E
R
Raise and Pull to remove. 
Wash and dry.
INDOOR UNIT
Vacuum the super 
alleru-buster fi lter.
Vacuum, wash and 
dry the frame.
Remove
● Clean the fi lter regularly as dirty fi lters will cause unpurifi ed air, low cooling or heating capacity, unpleasant smells and higher energy 
consumption.
●  The unit will become dirty and the performance of the unit will decrease after used for several seasons. Please consult an authorized 
dealer to perform seasonal inspections in addition to regular cleaning.
●  This air conditioner is equipped with a built-in surge protective device. However, in order to further protect your air conditioner from being 
damaged by abnormally strong lightning activity, you may switch off the power supply.
Hints
NON SERVICEABLE CRITERIAS
TURN OFF POWER SUPPLY and CALL Authorized Distributor under the following conditions:
•  Abnormal noise during operation  •  Circuit breaker switches off frequently
•  Water/foreign particles have entered the Remote Control  •   Power plug/cord becomes unnaturally warm
•  Water leak from Indoor unit  •   Switches or buttons are not functioning properly
ENGLISH
CARE & CLEANING
•  Wipe the unit gently with a soft, dry 
cloth.
•  It is recommended to clean the air 
fi lters once every 2 weeks.
• Purchase the replacement fi lter if it 
is damaged.
  Part no.: CWD001144
INDOOR UNIT
AIR FILTER
•  It is recommended to clean the fi lter 
every 6 months.
• Replace the fi lter every 3 years or 
purchase the replacement fi lter if it 
is damaged. 
  Part no.: CZ-SA13P
SUPER ALLERU-BUSTER
Vacuum, wash and dry.
PURIFYING DEVICE
Clean with cotton 
bud.
IONIZER
•  This inspection is recommended 
before operating the air conditioner 
at every season.
•  Check if the remote control batteries 
needed to be replaced.
•  Ensure there is no obstruction at all 
air intake and outlet vents.
•  After the start of operation for 15 
minutes, it is normal if the 
temperature differences between 
air intake and outlet vents at indoor 
unit is:-
Operation Temperature
Cooling
 8°C
•  Operate the unit for 2~3 hours using 
ion operation to dry the internal parts.
•  Turn off the power supply and unplug.
•  Remove the remote control batteries.
Switch off the power supply 
Switch off the power supply 
before cleaning
Remove
Remove
■ Washing Instructions
•  Do not use benzene, thinner or 
scouring powder.
•  Use soaps or neutral household 
detergent (
≃
pH7) only.
•  Do not use water with temperature 
higher than 40°C.
■ Pre-season Inspection
■ Preparation for extended 
Non-operation
•  It is recommended to clean the 
ionizer every 6 months.
IONIZER