10
How to use
iCOMFORT
To reach temperature quickly
• The unit controls set temperature according to room
temperature to accelerate room cooling.
Set temperature
iCOMFORT
-1°C
Max = 4 hours
• After max 4 hours, the set temperature follows the last
set temperature setting.
• Fan speed is fi xed at AUTO, fan speed selection is
prohibited.
• When the unit is off, pressing
iCOMFORT
will turn on the
unit with iCOMFORT mode.
• iCOMFORT mode can be cancelled by pressing the
respective button again.
SHOWER /
DIRECT
To enjoy shower or direct air
• This operation provides shower or direct air from the
unit.
• In SHOWER operation, the airfl ow is directed upwards
to provide radiant cooling.
• In DIRECT operation, the airfl ow is directed downwards
to provide fast cooling comfort.
• The fl ap will set to AUTO direction during SHOWER/
DIRECT operation.
• The operation can be cancelled by pressing the air
swing
button or respective button again.
MODE
To select operation mode
iCOMFORT - To reach temperature quickly
COOL - To enjoy cool air
DRY - To dehumidify the environment
nanoe-G
To purify the air
• When the dust sensor senses poor air quality, nanoe-G
will be activated.
• nanoe-G can be activated by pressing nanoe-G button.
• nanoe-G can be turned OFF manually by pressing
nanoe-G button or when the dust sensor senses good
air quality.
• The operation can be activated even when the unit
is turned off. In this condition, the unit will operate in
AUTO fl ap swing and AUTO FAN.
To deactivate viruses/bacteria on the fi lter
• After the unit is turned off, the nanoe-G in-fi lter
deactivation may activate up to 150 minutes. Turning
on the unit cancel this operation.
Press and hold for approximately
10 seconds to show temperature setting
in °C or °F.
RC
Press to restore the remote control to
default setting.
SET
AC
Not used in normal operations.
(Technical / Service Confi guration use)
Auto OFF/ON button
Indicator
Flap
Intake Grille
Use when remote control is misplaced or malfunction occurs. Pull the intake grille
downwards. If the Indicator Flap is in open condition, close it before pulling down the
intake grille.
•
To operate iCOMFORT mode, press the button once.
•
To operate COOL mode, press and hold the button until 1 beep is heard, then release.
•
To turn off the operation, press the Auto OFF/ON button.
If the Intake Grille is in close condition, close the Indicator Flap manually before
opening the Intake Grille and access the Auto OFF/ON button.
iCOMFORT
TEMP
TEMP
SHOWER /
DIRECT
OFF/ON
Indicator
Remote control receiver
Remote control display
(Operation condition)